Pass4Sure Designing for Cisco Internetwork Solutions : 640 863 Demo

Designing for Cisco Internetwork Solutions :Exam

1. Refer to the exhibit. Which statement accurately represents the characteristics of the core layer in this design?

A. QoS should be performed only in the core.

B. Load balancing should never be implemented or used in the core.

C. Access lists should be used in the core to perform packet manipulation.

D. It is acceptable to use a partial mesh in the core if it is connected to each device by multiple paths.

E. Policy-based traffic control is implemented in the core to enable prioritization, ensuring the best performance

for all time-critical applications.

B. lack of speed

C. high link utilization

D. uncertain reliability

E. excessive packet transmission rate

F. high expense of transmitting data

Answer: ABD

4. Refer to the exhibit. Which two statements describe why Model A is the recommended design for routing

between Building Distribution switches and Campus Core switches? (Choose two.)

A. It uses timer-based non-deterministic convergence.

B. It is software-based, providing fast convergence to the remaining path.

C. Routes are not summarized from distribution to the core.

D. The Layer 3 redundant equal cost links support fast convergence.

E. A link or box failure does not require routing protocol convergence.

Answer: DE

Answer: D

2. Which statement accurately describes one difference between a small office and medium office topology?

A. Small offices commonly use Rapid PVST+ for Layer 3 deployments.

B. Medium offices commonly use integrated route and switching platforms.

C. Medium offices use integrated 10/100/1000 interfaces as Layer 2 trunks.

D. Medium offices use external access switches to support LAN connectivity.

Answer: D

3. Which three factors best justify WAN link redundancy between geographically dispersed sites? (Choose three.)

A. important traffic flows

:Designing for Cisco Internetwork Solutions

:CCDA

certification includes:

:Designing Cisco Network Service Architectures Exam

:CCDP Designing Cisco network Service Architectures (ARCH)

certification includes:

:CCIE Pre-Qualification Test for Security (Lab exam)

:CCIE-ROUTING AND SWITCHING QUALIFICATION (Lab exam)

:CCIE Service Provider Written exam

:CCIE Service Provider Dial

:CCIE SP Content Networking ENU

:CCIE SP IP Telephony Qualification Exam

:CCIE SP Cable Qualification Exam

:CCIE SP Optical Qualification Exam

:CCIEStorage Networking

:CCIEVoice Written

:CCIE Written: Metro Ethernet

:CCIEWritten: WAN Switching

:350-001 Value Pack

:CCIEWritten, Service Provider: DSL

:350-018 Value Pack